Sealed Dual Stud Bulkhead Connector


Sealed Dual Stud Bulkhead Connector

Prices EXCLUDE GST and freight
Price reductions

The fuel pump power bulkhead terminal is designed specifically for anyone who is considering upgrading or has upgraded their OEM fuel pump to an aftermarket performance fuel pump (Walbro 255, Walbro 460, Walbro 520 etc).

An OEM electrical connector in unlikely to support the current and amperage requirements of these aftermarket pumps with most connectors rated at 7.5A; a single Walbro 460, depending on whether it is being used a surge-tank-supply pre pump or as the stand-alone supply pump, will draw 12A at the very least (less than 40psi fuel pressure) and up to 21A under high pressure (80psi+)

Simply cut a hole (26-28mm), insert the Power Terminal, secure both ends and connect your wires.  The oring has a burst seal strength well beyond 350psi so the manufacturer gurantees zero vapour loss.




Package Includes:

1 & 2. Power Terminal (Upper - POM black plastic/Lower - 6061-T6 purple anodise)

3. Viton Oring

4. Stainless Steel Power Studs (Upper M5/Lower M4)

*Plate depicted below for illustrative purposes only




Browse these categories as well: Fuel Tank Connectors, Insulated Studs, June 2020, Widest Range of Competition Electrical Components Available